ISO/TR 11696-1:1999

Publicado (Edición 1, 1999)

Esta norma se revisó y confirmó por última vez en 2017. Por lo tanto, esta versión es la actual.

CHF 173

Convertir Franco suizo (CHF) a tu moneda

Resumen

This Technical Report describes how information on basic values for ignition, spread of flame, rate of heat release

and smoke can be used in fire growth models for internal linings and other building products to describe the fire

hazard in a limited number of scenarios starting with fire development in a small room. Other scenarios include fire

spread in a large compartment and fire propagation down a corridor.

The types of models to be used are:

a) mathematical models based on fire growth physics, which calculate fire room variables, the results of which

may be used for fire safety engineering purposes; and

b) generalized engineering calculations.

Sub-models can be included within the above models, provided the consistency of the whole is not prejudiced.

The models in general are not limited to one fire scenario.

The models should be used to calculate and describe the fire properties of building products in their end-use

conditions. The use of models should not be limited by difficult materials, but it is recognized that some products

may not be capable of being modelled (for example due to their complex assembly or to their thermoplastic

properties).

Input parameters for models are based on ISO tests, mainly those in ISO/TR 3814.

The quality of a fire model for wall and ceiling linings is assessed by comparison with test results from a full-scale

small room test for surface products and by sensitivity analysis on the model itself.

Esta norma contribuye al siguiente Objetivo de Desarrollo Sostenible

Check out our FAQs

Customer care

+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)