ISO 5350-4:2006
p
ISO 5350-4:2006
39994

Текущий статус : Опубликовано (Hа стадии пересмотра)

Последний раз этот стандарт был пересмотрен в  2020. Поэтому данная версия остается актуальной
ru
Формат Язык
std 1 63 PDF
std 2 63 Бумажный
  • CHF63
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

ISO 5350-4:2006 specifies a method using instrumental inspection by reflected light for the estimation of visible dirt and shives in pulp manufactured in sheets, in terms of Equivalent Black Area (EBA) of dirt specks within the physical area range of 0,02 mm2 to 3,0 mm2. Using the algorithm prescribed in ISO 5350-4:2006, the maximum dirt size is limited to 3,0 mm2. Extension to other speck sizes (for example, those greater than 3,0 mm2 in physical area) may require changes in equipment, calculation procedures, or both, and is not covered in ISO 5350-4:2006. ISO 5350-4:2006 cannot be used for physical area measurements since it may not correctly measure the dirt specks for that mode of measurement.

The specimen to be evaluated should have a brightness, as determined by ISO 3688, of 30 % or greater. It may be necessary to reform some pulp sheets into laboratory sheets, if the surface is too rough or textured.

ISO 5350-4:2006 is also intended for recycled pulp.

Предпросмотр 

Вы можете ознакомиться с данным стандартом в нашей онлайн-библиотеке (OBP)

Общая информация

  •  : Опубликовано
     : 2006-09
    : Подтверждение действия между-народного стандарта [90.93]
  •  : 1
  • ISO/TC 6
    85.040 
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)