ISO 8662-11:1999

This standard has been revised by ISO 28927-13:2022

This part of ISO 8662 specifies a laboratory method for measuring the single-event vibration at the handle of

fastener driving tools, where a single event is a mechanical shock or a series of individual shocks at intervals longer

than 0,2 s. It is a type test procedure for establishing the vibration value in the handle of a hand-held power tool

operating under a specified load.

NOTE Fastener driving tools are also referred to as nailers, pinners, tackers and staplers.

For fastener driving tools to which this part of ISO 8662 is applicable, the power required for operation can be

supplied by pneumatic or hydraulic pressure, combustible gases in an internal combustion engine or from spring

tension. The fastener driving tools may be actuated by single actuation, contact actuation or continuous actuation.

This part of ISO 8662 is applicable to fasteners comprising nails, staples, pins, corrugated fasteners, screws used

as nails, dowels, sleeves, cable collars and base supports.

It is intended that the results of application of this part of ISO 8662 be used for comparing different models of the

same type of power tool.

Status
: Withdrawn

Publication date
: 1999-06
Edition
: 1

Number of pages
: 11
Technical Committee
: ISO/TC 118/SC 3 Pneumatic tools and machines
ICS
:
13.160 Vibration and shock with respect to human beings

25.140.10 Pneumatic tools

This standard contributes to the following Sustainable Development Goal:

Check out our FAQs

Customer care

+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)