This document collects available data on combined chemical resistance of thermoplastic materials typically used to manufacture piping components for industrial applications, against fluids over a range of temperatures.
The base thermoplastic materials covered by this classification are:
NOTE 1 The PE considered in this document corresponds to PE-HD, with a minimum density value of 0,935 g/cm3 (e.g.: PE63, PE80, PE100, PE100-RC, PE-RT).
Polypropylene PP (PP-R and PP-RCT, PP-H, PP-B)
Polyvinyl chloride, unplasticized PVC-U
Polyvinyl chloride, chlorinated PVC-C
Polyvinylidene fluoride PVDF
NOTE 2 This document considers homopolymer PVDF.
Cross-linked polyethylene PE-X (PE-Xa, PE-Xb, PE-Xc)
Ethylene chloro trifluoro ethylene ECTFE
Polyamide, unplasticized PA-U (PA-U11, PA-U12)
NOTE 3 This document focuses on PA-U11 and PA-U12 only, as these long chained PA-U are standardized according to ISO 16486-1; short chained (e.g. PA 66) and plasticized PAs are not used for monolithic plastic piping components.
NOTE 4 Temperatures higher than 200°C can be applied after an evaluation with the raw material manufacturer.
NOTE 5 Temperatures higher than 200°C can be applied after an evaluation with the raw material manufacturer.
Polyphenylene sulphide PPS
NOTE 6 PPS is new with regards to industrial application and chemical resistance issues; for this reason, manufacturers and end-users are advised to assess the chemical suitability of the material.
Status: PublishedPublication date: 2021-06
Edition: 2Number of pages: 215
Technical Committee: ISO/TC 138/SC 3 Plastics pipes and fittings for industrial applications
This standard contributes to the following Sustainable Development Goal:
Buy this standard
|std 1 208|
|std 2 208||Paper|
ISO/TR 10358:2021Stage: 60.60
Got a question?
Check out our FAQs
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)
Keep up to date with ISO
Sign up to our newsletter for the latest news, views and product information.