International Standard
ISO 16371-2:2017
Non-destructive testing — Industrial computed radiography with storage phosphor imaging plates — Part 2: General principles for testing of metallic materials using X-rays and gamma rays
Reference number
ISO 16371-2:2017
Версия 1
2017-09
International Standard
Предпросмотр
p
ISO 16371-2:2017
67690
недоступно на русском языке
Опубликовано (Версия 1, 2017)
Последний раз этот стандарт был пересмотрен в  2023. Поэтому данная версия остается актуальной.

ISO 16371-2:2017

ISO 16371-2:2017
67690
Формат
Язык
CHF 151
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

ISO 16371-2:2017 specifies fundamental techniques of computed radiography with the aim of enabling satisfactory and repeatable results to be obtained economically. The techniques are based on the fundamental theory of the subject and tests measurements. ISO 16371-2:2017 specifies the general rules for industrial computed X-rays and gamma radiography for flaw detection purposes, using storage phosphor imaging plates (IP). It is based on the general principles for radiographic examination of metallic materials on the basis of films, as specified in ISO 5579. The basic set-up of radiation source, detector and the corresponding geometry are intended to be applied in accordance with ISO 5579 and corresponding product standards such as ISO 17636 for welding and EN 12681 for foundry.

ISO 16371-2:2017 does not lay down acceptance criteria of the imperfections. Computed radiography (CR) systems provide a digital grey value image which can be viewed and evaluated on basis of a computer only. This practice describes the recommended procedure for detector selection and radiographic practice. Selection of computer, software, monitor, printer and viewing conditions are important but not the main focus of ISO 16371-2:2017.

The procedure it specifies provides the minimum requirements and practice to permit the exposure and acquisition of digital radiographs with a sensitivity of imperfection detection equivalent to film radiography and as specified in ISO 5579. Some application standards, e.g. EN 16407, can require different and less stringent practice conditions.

Общая информация

  •  : Опубликовано
     : 2017-09
     : 2018-04
    : Подтверждение действия между-народного стандарта [90.93]
  •  : 1
  • ISO/TC 135/SC 5
    19.100 
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)