недоступно на русском языке

Тезис

 Preview

This document specifies general dimensional and geometrical tolerances as well as machining allowance grades for castings using ± tolerances for indicated dimensions as delivered to the purchaser according to ISO/TS 8062-2. It is applicable for tolerancing of dimensions and geometry of castings in all cast metals and their alloys produced by various casting manufacturing processes.

This document does not apply to 3D CAD models used without indicated dimensions.

This document applies to both general dimensional and general geometrical tolerances (referred to in or near the title block of the drawing), unless otherwise specified and where specifically referred to on the drawing by one of the references in Clause 11.

The dimensional tolerances covered by this document are tolerances for linear dimensions.

The geometrical tolerances covered by this document are tolerances for:

—     straightness;

—     flatness;

—     roundness;

—     parallelism;

—     perpendicularity;

—     symmetry;

—     coaxiality.

This document does not cover other position tolerances, angular dimensional tolerances or cylindricity tolerances.

This document can be used for the selection of tolerance values for individual indications.


Общая информация 

  • Текущий статус
     : Опубликовано
    Дата публикации
     : 2023-02
  • Версия
     : 2
  • Технический комитет
     : ISO/TC 213 Dimensional and geometrical product specifications and verification
  • ICS
     :
    17.040.10 Limits and fits

Приобрести данный стандарт

Формат Язык
PDF + ePub
Бумажный
  • CHF145

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

  2. Интернет-магазин
  3. Каталог стандартов
  4. МКС
  5. 17
  6. 17.040
  7. 17.040.10
  8. ISO 8062-3:2023